本帖最后由 鲁哈哈 于 2020-12-23 15:13 编辑
一、打开CPU虚拟化,VT-X开机按“F2”: 选择第一个“system BIOS” 选择“Processor Settings” 将“Virtualzation technology”选择成为Enabled 二,关闭节能模式选择“System Profile Settings” 将电源选项选择为“Preformance” 三,修改RAID卡设置开机F2 选择Device Settings 选择需要执行操作的Raid卡: 在如下阵列卡主界面,选择“MainMenu” 在主菜单中,选择”Controller Management” 先清空磁盘的raid,选择“Clear Configuration” 查看磁盘状态
将阵列卡模式修改为HBA 在主菜单中,选择”Controller Management”下的”Advanced Controller Management” 点击”Manage Controller Mode” 在这个页面“Controller Mode“也可以看到目前控制器模式,点击”Switch to Enhanced HBA ControllerMode”转换成eHBA模式。 会出现Warning信息,勾选Confirm,点击Yes。 转换成功后,会看到多一行“Requested Mode“,需要重启服务器生效。 服务器重启后,在controller management下看到目前Controller Mode已是eHBA mode,在Manage Controller Mode下看到Auto – Configure Behavior是Non-RAID Disk。
在physical disk management看到所有硬盘状态都是NON-RAID 点击需要配置RAID的物理硬盘,物理硬盘操作界面:operation 下拉选择 Convert to RAID Capable,点击Go 勾选需要配置RAID的物理硬盘,点击OK,新页面勾选confirm,点击Yes 回到主页面选择“ConfigurationManagement”,再选择“CreateVirtual Disk”进行创建虚拟磁盘 修改系统盘为RAID1 选择“Create Virtual Disk” 选择raid1 再选择“Select Physical Disks” 勾选对应的硬盘做raid1点击Apply Changes 选择“Create Virtual Disk” 至此,配置完成。在Virtual Disk Management下可以看到创建的RAID状态,在Physical Disk Management下可以看到物理硬盘部分是online状态,部分是NON-RAID状态。(下图为例图) |